3-in-1 unit : Electronic hand dryer, papel towel dispenser and waste receptacle

SPECIFICATIONS :

Recessed paper towel dispenser and waste receptacle shall be type-304 stainless steel with all-welded construction; exposed surfaces shall have

satin finish. Unit equipped with TowelMate consisting of a 90° return towel guide angle inside cabinet to prevent paper towels from falling

forward out when door is opened for servicing and a Nylon Rod across the center of the towel tray to dispense paper towels one at a time. Door

shall be 1.2mm (18-gauge); have 14mm (9/16'') 90° return edges; be secured to cabinet with a concealed, full-length stainless steel piano-hinge;

and equipped with a stainless steel cable door-swing limiter and two tumbler locks keyed like other Bobrick washroom accessories. Tumbler

locks flush with the door - no protrusion. Paper towel dispenser shall be capable of dispensing 450 C-fold, 600 multifold, or 850 singlefold paper

towels. Waste receptacle shall be furnished with a removable, leak-proof, rigid molded plastic waste-container with a capacity of 12.5 liters. (3.3-

gal.). Air deflector shall prevent dryer from blowing into waste container.

Hand dryer shall have a one-piece, fire-retardant molded, Bobrick grey color #889. Mounting base and fan housing shall be fire-retardant

molded plastic with high-gloss grey finish. Brushless motor shall be 1500-1700 watts, external rotor type with sealed ball bearings on ends of

drive shaft and equipped with an automatic thermal-overload switch. Centrifugal fan shall have multiple metallic vanes. Heating element shall

be located on inlet side of fan, shall heat without hot spots, be inaccessible to vandals, and protected by an automatic thermal-overload switch.

Electronic sensor shall automatically turn dryer on when hands are held under air-outlet opening and across path of sensor. Dryer will turn off

automatically when hands are removed. Sensor shall automatically shut dryer off approximately two minutes after dryer turns on if inanimate

object is placed across sensor lens. After inanimate object is removed, electronic sensor shall automatically reset itself and dryer shall operate

normally. Unit shall be VDE approved, CE marked and protected by a limited 1-year warranty on all parts.